Dupont Bridge Maker

Turn loose jumper wires into one locked connector. Drop the housings in, snap the lid on, no crimping.

5 pins, single row

How to use

Print the 2-pin version first as a fit test. PETG is best for the snap, PLA works.
0.12 to 0.16 mm layers, no supports. Files are already in print orientation.
Lid too loose or too tight: change Lid gap. Housings won't drop in: raise Side clearance.
Lay the housings in with the latch window facing up, pin 1 at the triangle, then press the lid on until it clicks.

Loading geometry engine

BodyLidHousing